Skip to content

Send Art-Net Timecode

We start with an empty project. To start Sending Art-Net Timecode, you click on the add component '+' button on the top left of the start screen.

In the bar that pops up, you click 'Sender'.

A Sender is added to your project. You select 'Art-Net' as the output mode by clicking the [Art-Net] button, which will then turn green.

To configure the Art-Net output, you click the settings button. Here you can set the following settings:

  • The frame rate. You can choose between the following frame rates:
    • 24 FPS
    • 25 FPS
    • 30 FPS
    • 29.97 FPS DF
  • The Art-Net output IP-address: The IP-address to send the Art-Net to. The network adapter to use is automatically picked based on the filled IP-address.

Make sure to select the preferred audio output at [Options] -> [Preferences] -> [Audio] -> 'Output', and select the channels to be active at 'Active output channels'

  • The offset: Here you can set the offset to be applied to the Sender. You can set an offset by hours, minutes, seconds, and the decimal, as selected as the clock display mode.
  • The clock display mode
    • HH:MM:SS:FF: Hours:Minutes:Seconds:Frames
    • HH:MM:SS:MM: Hours:Minutes:Seconds:1/100th seconds
    • HH:MM:SS:MMM: Hours:Minutes:Seconds:Milliseconds
    • HH:MM:SS: Hours:Minutes:Seconds

When you have a left-side component running, for example a Generator, and you draw a routing from the Generator to your Art-Net Sender, Art-Net will be outputted to the chosen IP-address.